ETAP Power Systems 2 ELCL 9102
Online Course Above Description
This is an Online course "Above Description Content" test text field.
This is an Online course "Description" test text field.
Online Course Below Description
This is an Online course "Below Description Content" test text field.
Online Course Additional Information Note
This is an Online course "Additional Information Note Content" test text field.
Online Course Disclaimer
This is an Online course "Disclaimer Content" test text field.
Our ETAP Power Systems 2 course teaches you how to use ETAP Power Station software to run unbalanced network load flow analysis, unbalanced network short circuit analysis, harmonics filter analysis, dynamic motor acceleration analysis, power factor correction, battery sizing calculation, protective device coordination, optimal capacitor placement, and many other.
Prerequisites
You must have completed our ELCL 9101 ETAP Power Systems 1 course.
Hours and Fees
Hours
48
Fee
$454.20
There are no classes currently scheduled for this course; however, check back to see if we have developed additional schedules for the upcoming term. Classes for our 2025–26 academic year will launch in early July.
- Contact Information
- Contact Department:
- Construction, Technology & Trades Department
- Email:
- cetechnology@georgebrown.ca
- Phone:
- 416-415-5000, ext. 4861
- Office Location(s):
- Casa Loma Campus, 160 Kendal Ave., Building C (CLC), Room C426
Read about our textbooks policy, and remember that the Continuing Education attendance policy and closure dates differ from those for full-time college programs.